Drill Guide for Mating Holes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
You know the age old problem - You want to build a bed out of scaffold boards, but you are cack at the following: 1)…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 33
- Makes
- 0
- Views
- 442
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
You know the age old problem - You want to build a bed out of scaffold boards, but you are cack at the following:
1) Measuring things;
b) Using a drill;
iii) Consistent lists.
But you have a 3D printer...
FEAR NOT, Stu has got your back. Hole Guide Part 1 is designed to use a 25mm flat blade to put a hole through a scaffold board, and then a 10mm drill bit to drill a hole in the end which goes through the middle of the 25mm hole.
Part 2 is designed to fit over the end of a second board and let you drill a companion 10mm hole. All you then need to do is bolt it up, and you are halfway closer to not sleeping on a mattress on the floor.
SCADs are included so you can remix them for any hole/wood you might have.
Print instructions
I personally used 0.2mm and roughly 30% infill...but i'm certain that part isn't all too important. You will need to support the guides however.
When I printed them, I oriented a flat side down. I'd suggest you do the same!