Rim for Pringles penholder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I decided to make a simple pen holder out of a pringles can, after cutting it to length I realized the exposed cut…
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 30
- Wydruki
- 1
- Wyświetlenia
- 237
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
I decided to make a simple pen holder out of a pringles can, after cutting it to length I realized the exposed cut section is rather sharp and can get wet much quicker than the rest of the can, so I made a simple rim for it.
just print it with the slot facing upwards and then fit it onto the can.
I tried the original lid but it is a very tight fit, if you glue it down it might work with the lid.
of course, you will need to cut the can and ideally a very smooth flat cut.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
higher the better, i used 0.8 but of course you can do like 0.2
Infill:
100%
Filament: Purefil of switzerland PLA concrete gray Post-Printing =============
clean up the print and fit it onto the can starting from one side
How I Designed This
Solidworks Student
Category: Containers