E3D V6 Hinged Extruder Bracket & Clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A hinged bracket designed to carry an E3D V6 extruder. This remix adds a hinge system that opens to approx. 90 degrees…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 228
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
A hinged bracket designed to carry an E3D V6 extruder.
This remix adds a hinge system that opens to approx. 90 degrees to allow easier/quicker access for maintenance.
Instructions
Print it all at 0.2mm with 20 - 25% infill. Support material is advisable when printing the bracket section.
The printed pin works well to fix the hinge - I found it best to keep it pretty rough on the clean-up.
The clamp is locked by an M3 @ 20mm (or slightly longer) bolt and nut. If the bolt is slightly long just heat it and push it into the hole until you have enough clearance.
Category: 3D Printer Extruders