Turnigy D2826 2200kV Motor Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Motor mount for the Turnigy 2826, 2200kV motor. Another little project off the smokey Anet A8! Two versions; a 90 deg…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 71
- Wydruki
- 0
- Wyświetlenia
- 400
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Motor mount for the Turnigy 2826, 2200kV motor.
Another little project off the smokey Anet A8!
Two versions; a 90 deg angle mount, good for front mounting. Also a 12 deg tilted mount, which is good for pusher mounting.
Also a raised open platform to get the motor higher up. I used the tilted mount and platform combination on the little Mugi Coreflute / Corro / Correx Flying Wing.
Recommend printing motor mounts with multi-hole (motor) part on the build plate. No need for supports; drill out the four mounting holes if they are a bit out of round.
For the raised platform lay it down as per the picture; so again no need for supports while printing.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
100% (solid)
Filament: Any PLA Any
Notes:
Recommend printing with multi-hole (motor) part on the build plate. No need for supports; drill out the four mounting holes if you need to to make them round again.
Category: R/C Vehicles