Turnigy D2826 2200kV Motor Mounts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Motor mount for the Turnigy 2826, 2200kV motor. Another little project off the smokey Anet A8! Two versions; a 90 deg…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 69
- Makes
- 0
- Views
- 398
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Motor mount for the Turnigy 2826, 2200kV motor.
Another little project off the smokey Anet A8!
Two versions; a 90 deg angle mount, good for front mounting. Also a 12 deg tilted mount, which is good for pusher mounting.
Also a raised open platform to get the motor higher up. I used the tilted mount and platform combination on the little Mugi Coreflute / Corro / Correx Flying Wing.
Recommend printing motor mounts with multi-hole (motor) part on the build plate. No need for supports; drill out the four mounting holes if they are a bit out of round.
For the raised platform lay it down as per the picture; so again no need for supports while printing.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
100% (solid)
Filament: Any PLA Any
Notes:
Recommend printing with multi-hole (motor) part on the build plate. No need for supports; drill out the four mounting holes if you need to to make them round again.
Category: R/C Vehicles