Williams Strike Master Bowling Pin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement pin for Williams strike master. It should fit any other bowler that uses a 10 1/4" pin. I found…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 408
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a replacement pin for Williams strike master. It should fit any other bowler that uses a 10 1/4" pin. I found these were slightly heavier than the originals, so I shortened the up spring by 3-4 loops and it works perfectly.
I used this file as a base to design, but thingiverse isn't allowing me to add a remix right now.
https://www.thingiverse.com/thing:15859
You will need a tall printer to print these as it's taller than 250mm. The game is currently on location and the pins are holding up really well.
Print Settings
Printer:
Custome Tronxy x3a
Rafts:
No
Supports:
No
Resolution:
0.4mm
Infill:
10
Filament:
D3D pla
Gold Silk
Notes:
I use a wide brim to stabilize.
Category: Electronics