Williams Strike Master Bowling Pin
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a replacement pin for Williams strike master. It should fit any other bowler that uses a 10 1/4" pin. I found…
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 51
- Makes
- 0
- Views
- 408
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
This is a replacement pin for Williams strike master. It should fit any other bowler that uses a 10 1/4" pin. I found these were slightly heavier than the originals, so I shortened the up spring by 3-4 loops and it works perfectly.
I used this file as a base to design, but thingiverse isn't allowing me to add a remix right now.
https://www.thingiverse.com/thing:15859
You will need a tall printer to print these as it's taller than 250mm. The game is currently on location and the pins are holding up really well.
Print Settings
Printer:
Custome Tronxy x3a
Rafts:
No
Supports:
No
Resolution:
0.4mm
Infill:
10
Filament:
D3D pla
Gold Silk
Notes:
I use a wide brim to stabilize.
Category: Electronics