Wire Management for V-Slot Printers (MakerFarm i3v)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here are the parts I use to manage and hide the wires on my MakerFarm i3v printers. The cable clips snap into the…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 199
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Here are the parts I use to manage and hide the wires on my MakerFarm i3v printers.
- The cable clips snap into the grooves of the V-Slot extrusions to hide wires inside.
- The end strain relief mounts to the end of an extrusion with a 5mm screw and T-nut to provide a place to tie off wires.
- The groove plate slides into the end of the extrusion to capture and hide smaller wires.
Instructions
I use these parts to route and hide the X motor and X and Y endstop wires on my MakerFarm i3v printers. The X motor and endstop come into the X axis assembly from the right with a single cable bundle. The motor wires run the length of the extrusion, hidden under cable clips.
I also use the cable clips to route the wires under the extrusion to the Y endstop switch.
The snap-in clips fit pretty well when printed in ABS with a .4mm Hexagon, .2mm layers.
Category: 3D Printer Parts