Negative tolerance test
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Once printed, push out as many pegs as you can. The numbers on the sides indicate the gap width between the triangular…
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 84
- Wydruki
- 5
- Wyświetlenia
- 464
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Once printed, push out as many pegs as you can. The numbers on the sides indicate the gap width between the triangular case and each peg, in millimeters.
On my own print, I was able to remove the 0.20mm and up, but the 0.15 and lower were stuck fast. I think that's pretty standard. If you can get better, I'd be curious to know what printer you're using.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
No
Resolution:
Any
Infill:
0%
Notes:
Shouldn't be necessary to use any infill, raft, or supports. Just print as-is, at any layer-height you like - I used 0.08mm.
Category: 3D Printing Tests