Negative tolerance test
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Once printed, push out as many pegs as you can. The numbers on the sides indicate the gap width between the triangular…
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 84
- Makes
- 5
- Views
- 464
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Once printed, push out as many pegs as you can. The numbers on the sides indicate the gap width between the triangular case and each peg, in millimeters.
On my own print, I was able to remove the 0.20mm and up, but the 0.15 and lower were stuck fast. I think that's pretty standard. If you can get better, I'd be curious to know what printer you're using.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
No
Resolution:
Any
Infill:
0%
Notes:
Shouldn't be necessary to use any infill, raft, or supports. Just print as-is, at any layer-height you like - I used 0.08mm.
Category: 3D Printing Tests