Mushroom Slug Trap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the Mushroom slug trap / Piège à limaces Champignon by xfifi at…
- Ocena
- 4,75 / 5
- Polubienia
- 44
- Pobrania
- 275
- Wydruki
- 5
- Wyświetlenia
- 1280
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the Mushroom slug trap / Piège à limaces Champignon by xfifi at https://www.thingiverse.com/thing:2205074.
The three top supports went straight down into the bottom, letting the slugs climb out. I removed the three pillars and beveled the edges, making it easy to print without supports.
There was plenty of room in the design so I cut back the reservoir as well, making it a steeper reverse slope, thus even harder for the slug to climb out of.
I printed this at 0.175 resolution, 10% infill on both.
If you're using Cura, under Shell enable both Concentric Top/Bottom layer and Concentric Bottom Pattern Initial Layer. This helps it stay watertight, and is a must for pots.
4 walls, 5 top/bottom layers.
40 mm/s
No supports needed for the bottom, and 10% Line Touching Buildplate supports needed for the top (the slots).
Print Settings
Printer Brand:
Monoprice
Printer:
Select Mini
Rafts:
No
Supports:
Yes
Resolution:
0.175
Infill:
Line 10%
Filament: AIO Robotics PLA Red, White
Category: Outdoor & Garden