Mushroom Slug Trap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of the Mushroom slug trap / Piège à limaces Champignon by xfifi at…
- Rating
- 4.75 / 5
- Likes
- 44
- Downloads
- 275
- Makes
- 5
- Views
- 1,280
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the Mushroom slug trap / Piège à limaces Champignon by xfifi at https://www.thingiverse.com/thing:2205074.
The three top supports went straight down into the bottom, letting the slugs climb out. I removed the three pillars and beveled the edges, making it easy to print without supports.
There was plenty of room in the design so I cut back the reservoir as well, making it a steeper reverse slope, thus even harder for the slug to climb out of.
I printed this at 0.175 resolution, 10% infill on both.
If you're using Cura, under Shell enable both Concentric Top/Bottom layer and Concentric Bottom Pattern Initial Layer. This helps it stay watertight, and is a must for pots.
4 walls, 5 top/bottom layers.
40 mm/s
No supports needed for the bottom, and 10% Line Touching Buildplate supports needed for the top (the slots).
Print Settings
Printer Brand:
Monoprice
Printer:
Select Mini
Rafts:
No
Supports:
Yes
Resolution:
0.175
Infill:
Line 10%
Filament: AIO Robotics PLA Red, White
Category: Outdoor & Garden