simplex derailleur gear
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Turned out my derailleur tension gear - a part of my bike I newer paid any attention to - is completely worn down. Up…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 553
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Turned out my derailleur tension gear - a part of my bike I newer paid any attention to - is completely worn down. Up to a point where I wasn't able to make out any gears at all or count the teeth or move it with my fingers.
Good news though: It's made of plastic. So I just redesigned the part to a shape that I imagine would be similar to original and it worked out to be a perfect fit.
It fits simplex type of gear shift systems or whatever these things are called and in my case it's mounted on a Puch Clubman street bike from the 80ies or so.
Print Settings
Printer:
P220
Rafts:
No
Supports:
Yes
Resolution:
0,25mm
Infill:
100%
Filament:
3dxtech PEI-GF30
natural
Notes:
I guess this isn't a requirement but since I had to tune in some settings for this fancy high-performance filament, I used this part as a test print and it turned out almost perfect. Layer adhesion though still leaves a bit to desire - at 400°C nozzle! Guess an ambient temp of 180°C still isn't enough.
As so often with my designs I didn't make a lot of compromises in order to make it printable, so use it with a lot of support. And maybe some temperature resistant rigid material... I guess polycarbonate would be fine, maybe even PETG?Category: Sport & Outdoors