3D Printer Fan Hub Controller for CTC / Flashforge / Replicator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I built an internal and manual fan controller for up to 5 standard 12V PC-Fans.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 653
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I built an internal and manual fan controller for up to 5 standard 12V PC-Fans. It should fit many different printers, but I designed it for my Replicator-Clone.
The Fan controller I used was the Aerocool F5XT:
http://www.aerocool.com.tw/en/fan-controller/single-bay/f5xt
The circuit board can be loosened very easy and the buttons / sliders are only clipped in place.
First I printed the "Mount Pattern" and drilled the mounting holes and the slots for the sliders (using a 3mm drill).
Then I printed the spacers, buttons and covers and all fits together with only 2 M3 Screws (or other if you use a bigger drill).
Note: The cover does not have any holes, you have to glue it in place or (like me) drill the holes by hand. I did this, becaus a miss-aligned the mount pattern a little bit and could fix it in this way.
UPDATE 03/12/2016
I added the Slider Button V2 (tighter tolerances). I also Uploaded the .stp for the slider button so you can adjust the design, if you find they wont fit properly.
Print instructions
Category: 3D Printer Accessories Print Settings
Printer: CTC 3D
Rafts: Doesn't Matter
Supports: Doesn't Matter
Resolution: 0.2
Infill: 15%