1 / 10
Dial Gauge Mounts for 3 Axis Calibration (X, Y, and Z) — zdjęcie 1
1 / 10

Dial Gauge Mounts for 3 Axis Calibration (X, Y, and Z)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These mounts allow step calibration for all 3 axes of your printer, providing a firm and secure mount for a dial…

Ocena
0 / 5
Polubienia
15
Pobrania
184
Wydruki
1
Wyświetlenia
1050
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

These mounts allow step calibration for all 3 axes of your printer, providing a firm and secure mount for a dial gauge. These should work with any printer that uses 20mm V-slot or T-slot rail for the XZ axis mount, and any V-slot or T-slot rail for the Y axis mount.

It is designed for a gauge with an approximate 57.7mm diameter body and 9.6mm diameter shaft sleeve, but it should work for slightly smaller gauge bodies. The top-end clip provides secure support for the gauge, but does not require an exact fit. I am using the Clockwise Tools DIGR-0105 gauge, as shown in the pictures.

The mounting holes are designed for M3x10 or M3x8 screws and T-nuts to hold the mounts securely in place. I used one of the printable M3 T-nut designs available on the site.

The XZ mount should simply clip to the crossbar with no screws, but holes are provided if necessary. The Y mount will require screws and T-nuts.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

.2

Infill:

20

Filament: IIIDMax PLA+ Space Gray


Notes:

I printed with 3 walls, no special settings otherwise.

Post-Printing =============

The bottom supports for the XZ mount may leave the surface and rail clip edges a bit rough, but cleanup should be quick and simple with cutters and possibly some light filing.

The XZ mount should clip securely to the X axis rail in both orientations, but if it doesn't then use screws and T-nuts to secure it.

In an ideal world, your printer would be fully calibrated for a perfect fit, but then you wouldn't need these mounts. If the XZ axis clips are in the way, simply cut them off and use screws and T-nuts.

How I Designed This

While I liked the gauge end support from the original design, I was unable to find a good all-axis solution. Also, I felt that the X and Z axis could easily be handled by a single part, without resorting to using a gauge block.

After a few test prints, I decided that the top of the gauge needed more support than the original design provided. I replaced the simple support with a more robust solution, so the gauge clips firmly into place and is held securely in any orientation.

I originally wanted the Y axis to either clip on, or have a supporting ledge resting on the top of the bed rail. However this proved to be unreasonable when I took into account the narrow bed profile and the fact that leveling the bed may raise or lower it to a position the gauge couldn't measure. In the end, I decided that simple cutouts for the screws would be the best, most flexible solution.

Category: 3D Printer Accessories

Tagi