Porsche 944 / 968 Rear Main Seal Installation Tool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Porsche 944 RMS installation tool by Big Dick Racing.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 211
- Wydruki
- 1
- Wyświetlenia
- 1545
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
I didn't want to pay $200+ for a Sir Tools P234 arbor so I whipped this up. I sell these for $15 if you do not have 3D printing capability, but I am offering it (for NON-COMMERCIAL usage) here. That means you are not printing these and selling them. The 944 community is small and I will probably find out quickly.
Instructions are also attached.
As far as printing, I suggest:
- PLA, 25-40% infill (cubic, or something else which is reasonable)
- I have used PETG for these in the past and the supports do not release as cleanly, leaving the threads a bit knackered. YMMV.
- 0.2mm layer height, 0.5mm line width, 3 perimeters.
- Tree supports at 60 deg angle trigger point
- Ironing enabled for top surface only
- Monotonic top/bottom layer
You will notice that the threads may be a bit sticky and hard to spin, unless your extrusion calibrations / tolerances are bang-on. I found it's easiest to take a small bit of grease or assembly lube and apply a few small smears to the male threads. Work the 2 pieces together until they spin smoothly through the whole range of travel. Works every time.