1 / 4
Porsche 944 / 968 Rear Main Seal Installation Tool — image 1
1 / 4

Porsche 944 / 968 Rear Main Seal Installation Tool

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Porsche 944 RMS installation tool by Big Dick Racing.

Rating
0 / 5
Likes
16
Downloads
211
Makes
1
Views
1,542
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial

I didn't want to pay $200+ for a Sir Tools P234 arbor so I whipped this up. I sell these for $15 if you do not have 3D printing capability, but I am offering it (for NON-COMMERCIAL usage) here. That means you are not printing these and selling them. The 944 community is small and I will probably find out quickly.

Instructions are also attached.

As far as printing, I suggest:

  • PLA, 25-40% infill (cubic, or something else which is reasonable)
    • I have used PETG for these in the past and the supports do not release as cleanly, leaving the threads a bit knackered. YMMV.
  • 0.2mm layer height, 0.5mm line width, 3 perimeters.
  • Tree supports at 60 deg angle trigger point
  • Ironing enabled for top surface only
  • Monotonic top/bottom layer

You will notice that the threads may be a bit sticky and hard to spin, unless your extrusion calibrations / tolerances are bang-on. I found it's easiest to take a small bit of grease or assembly lube and apply a few small smears to the male threads. Work the 2 pieces together until they spin smoothly through the whole range of travel. Works every time.

Tags