1 / 2
Thread Finder - SAE — zdjęcie 1
1 / 2

Thread Finder - SAE

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A set of thread testers for nuts and bolts, U.S. / SAE standard.

Ocena
5 / 5
Polubienia
51
Pobrania
450
Wydruki
1
Wyświetlenia
1574
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Share Alike

This is a set of thread testers for nuts and bolts, U.S. / SAE standard. Similar to the “Thread Detective” where one side tests a nut, the other side tests a bolt. Thread sizes are embossed on the side of each tester.

This is a set in common SAE sizes.

There is a hole through the side of the testers to hang them from a chain or rope.

These should print fine if your printer is dialed in pretty well. Make sure initial layer / elephant foot compensation is set up otherwise it may be hard to get a screw threaded.

I would think these would print well on a SLA resin printer if you have “Tolerance compensation” configured in Chitubox or “Elephant foot compensation” in PrusaSlicer.

Print Settings

Printer: Ender 3 Pro w/ direct drive

Material: PLA or PETG

Rafts: No

Supports: No

Resolution: 0.15-0.2mm

Infill: 15% or higher

Shells: 2+

Note: These came out solid enough in my opinion with 15% cubic infill.

Tagi