Thread Finder - SAE
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A set of thread testers for nuts and bolts, U.S. / SAE standard.
- Rating
- 5 / 5
- Likes
- 51
- Downloads
- 450
- Makes
- 1
- Views
- 1,574
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
This is a set of thread testers for nuts and bolts, U.S. / SAE standard. Similar to the “Thread Detective” where one side tests a nut, the other side tests a bolt. Thread sizes are embossed on the side of each tester.
This is a set in common SAE sizes.
There is a hole through the side of the testers to hang them from a chain or rope.
These should print fine if your printer is dialed in pretty well. Make sure initial layer / elephant foot compensation is set up otherwise it may be hard to get a screw threaded.
I would think these would print well on a SLA resin printer if you have “Tolerance compensation” configured in Chitubox or “Elephant foot compensation” in PrusaSlicer.
Print Settings
Printer: Ender 3 Pro w/ direct drive
Material: PLA or PETG
Rafts: No
Supports: No
Resolution: 0.15-0.2mm
Infill: 15% or higher
Shells: 2+
Note: These came out solid enough in my opinion with 15% cubic infill.