1 / 4
Beefy Keenovo Wire Strain Relief for CR-10 — zdjęcie 1
1 / 4

Beefy Keenovo Wire Strain Relief for CR-10

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

"Beefy" cable strain management solution for a Keenovo + CR-10. Didn't want a cable chain. Didn't want to drill holes.…

Ocena
0 / 5
Polubienia
0
Pobrania
18
Wydruki
0
Wyświetlenia
329
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

"Beefy" cable strain management solution for a Keenovo + CR-10. Didn't want a cable chain. Didn't want to drill holes. But I wanted a secure way of attaching the strain relief to the bed of my CR-10. So this is my solution. Probably overkill, but it works really well (so far).

I have the wires in a nylon sleeve and electrical tape to secure the end near the heat pad. Instead of a fancy cable chain, I just velcro'd the cable to the back of the Y-axis motor. No rubbing and super simple.

The version here is slightly modified from my picture to remove the guide walls closest to the heat bed to avoid having to cram the wires in too close to the heat pad. I don't have a second zip tie in my picture because of this. With this version, you should use both zip ties.

UPDATE: Added two new versions. v2 is the one I'm currently using. v3 is designed to attach more securely directly to the carriage. Both were significantly "beefed up" to try to avoid sagging and were redone in Fusion 360 (friends don't let friends use TinkerCad for anything more complex than a donut). Print these using ABS or PETG to avoid sagging. Even though they won't get very hot if you are using an insulating pad below your Keenovo, it's warm enough for PLA to sag down and essentially cause this to drag back and forth on the belt. Don't do what I did...I've now printed them in PETG and all is fine after a number of months of use.

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

No

Supports:

No

Resolution:

0.2mm layer height

Infill:

30%

Filament: Any PETG, ABS or other heat tolerant option

Notes:

No special printing requirements. Choose a heat-tolerant material. Might want a few extra walls and decent infill to make it as rigid as possible.

The screw holes are covered with a single layer of plastic to make the print slightly easier to print if you have an uneven bed. Just poke through them with a screw.

Category: 3D Printer Accessories

Tagi