Ender 3 V2 Ring Light Mounting Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting clip to attach a 260mm ring light to Ender 3 V2 gantry bar.
- Ocena
- 0 / 5
- Polubienia
- 41
- Pobrania
- 107
- Wydruki
- 0
- Wyświetlenia
- 1007
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
A simple clip to attach a ring light to the top gantry bar of the Creality Ender 3 V2.
I wanted to mount a 260mm ring light to my gantry bar to provide light across the entire print bed as some light bars cause a shadow to be cast by the print head. The ring light helps eliminate some shadowing.
You will require 2 clips to be printed, one for each end of the gantry.
The clip is best printed with 100% infill for best stability and strength. Supports are required but be very careful when removing support structure from the smaller prongs of the clip to avoid snapping. I printed the clip at 0.2mm resolution but feel free to adjust to suit your preference.
(This clip was designed to fit a Creality Ender 3 V2 but may also fit other Ender models, the ring light was 260mm diameter, 25mm edge width and 17mm thick.)
If you enjoy this print then please do share your make, I would love to see what colours and filaments you chose for your print.
If you have any questions about 3D printing, whether it be queries or you need some tips or tricks feel free to reach out in the comments or by message, I am always more than happy to help if I can!