Ground Chair 500
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is modification to Decathlon MH500 low camping chair. "DECATHLON MH500 LOW CHAIR" is low cost 35EUR…
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 1167
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution
This is modification to Decathlon MH500 low camping chair.
"DECATHLON MH500 LOW CHAIR"
- is low cost 35EUR camping/hiking chair from decathlon.
- weight as bought 1102g
- product concept = light aluminum tube frame + hanging fabric sitting surface.
"GROUND CHAIR 500"
- is modification of Decathlon MH500
- New corners are 3D printed.
- Tubes are re-assembled into different configuration.
- The same fabric is reused.
(inspired by "helinox ground chair" concept, which is ~120EUR camping chair).
Ground Chair 500 is improved over Decathlon:
- weight 0.89kg vs 1.1kg
- lower position - can sit even inside tent
- no pointy legs - can place on tent floor or loose sand
- works comfortably on slope (even better than on flat)
Print Settings
Supports:
No
Filament:
generic PETG,PLA
Notes:
There are 4 STLs to print - one for each corner. (FR = front right...).
Printed in PLA and PETG, at 0.3mm layer, using 4 perimiters (2mm wall) and 20% infill.Set of 4 corners weight around 140g.
I found this pipe layout, sleeve depth, corner size optimal for myself.
Both in PLA and PETG was sufficient for holding my weight and not breaking during normal use.
I have not done durability test (repetive stress may cause failure).
I have not done impact test (banging on stone may break corner).
Or tested how much abuse they can withstand (like jumping or testing strengh upside down).
Category: Sport & Outdoors