Ground Chair 500
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is modification to Decathlon MH500 low camping chair. "DECATHLON MH500 LOW CHAIR" is low cost 35EUR…
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 43
- Makes
- 0
- Views
- 1,167
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Sports
- License
- Creative Commons — Attribution
This is modification to Decathlon MH500 low camping chair.
"DECATHLON MH500 LOW CHAIR"
- is low cost 35EUR camping/hiking chair from decathlon.
- weight as bought 1102g
- product concept = light aluminum tube frame + hanging fabric sitting surface.
"GROUND CHAIR 500"
- is modification of Decathlon MH500
- New corners are 3D printed.
- Tubes are re-assembled into different configuration.
- The same fabric is reused.
(inspired by "helinox ground chair" concept, which is ~120EUR camping chair).
Ground Chair 500 is improved over Decathlon:
- weight 0.89kg vs 1.1kg
- lower position - can sit even inside tent
- no pointy legs - can place on tent floor or loose sand
- works comfortably on slope (even better than on flat)
Print Settings
Supports:
No
Filament:
generic PETG,PLA
Notes:
There are 4 STLs to print - one for each corner. (FR = front right...).
Printed in PLA and PETG, at 0.3mm layer, using 4 perimiters (2mm wall) and 20% infill.Set of 4 corners weight around 140g.
I found this pipe layout, sleeve depth, corner size optimal for myself.
Both in PLA and PETG was sufficient for holding my weight and not breaking during normal use.
I have not done durability test (repetive stress may cause failure).
I have not done impact test (banging on stone may break corner).
Or tested how much abuse they can withstand (like jumping or testing strengh upside down).
Category: Sport & Outdoors