SD card case/protector w/ label (remix/OpenSCAD)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
SD card case/protector w/ a small space for a label. This is a remix done in OpenSCAD.
- Ocena
- 4,889 / 5
- Polubienia
- 226
- Pobrania
- 895
- Wydruki
- 33
- Wyświetlenia
- 3559
- Oceny
- 27
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a quick couple of SD card/SDcard cases the other day and downloaded/printed Rod's SD Card Holder remix of guytas's SD card labelling case - both are great models.
However, I was looking for something a little bit smaller. Although from scratch, I used Rod's model as a guide to generate my model, which nicely secures the SD card w/ a printed spring. In my model's case, the label is much smaller - only the width of the card, but it protects the card nicely and securely and allows for a nice short label.
I printed in PLA, .2mm layer height, 20% infill. Uses .825 meters of filament.
UPDATE 2022-05-18: Now with a “keyhole” version for putting on a key chain.
UPDATE 2022-06-06: By request - a version without the label “flag”.