1 / 6
Hama IR100 / NAP810F Buttons — zdjęcie 1
1 / 6

Hama IR100 / NAP810F Buttons

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

After a few years of undeniable joy my "IR100" (made by Hama) Internet Radios buttons became more and more sticky…

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
112
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

After a few years of undeniable joy my "IR100" (made by Hama) Internet Radios buttons became more and more sticky (silicon surface). I designed these buttons to replace the original ones which can be removed by gently pulling them off their encoders.

Although I designed them for the "IR100", they will most likely fit many other models and some encoders, too: The connector hole is 6mm inner diameter and has a minimum width of 4.5mm to the flat side.

Print Settings

Printer:

Velleman Vertex K8400

Rafts:

No

Supports:

No

Resolution:

0.1mm

Infill:

100%

Filament:

Nunus PETG

Black


Notes:

I always print on heated glass surface with water soluble glue for better adhesion.

Post-Printing

Replacement Procedure for Hama "IR100"

  • Don't break things
  • Remove the original buttons by gently pulling them along their symmetrie axis (away from the radio). Take printed spare part and orient it (connector only fits in one position!) Push gently Make sure the part is oriented correctly and push a little heavier, it's a tight fit part

Category: Replacement Parts

Tagi