Ender 6 Modified Cable Chain Mount and Petsfang Duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I know Petsfang ducts work well and I wanted a good 5015 fan duct for my Ender 6 but the design I found on MakerForum…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 97
- Wydruki
- 0
- Wyświetlenia
- 1404
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I know Petsfang ducts work well and I wanted a good 5015 fan duct for my Ender 6 but the design I found on MakerForum made by Makermike wouldn’t clear the cable chain mount I installed.
After a bit of tinkering I found if I reduced the thickness of the cable chain mount by half and removed the two nubs that stick out at the back of the Petsfang duct it JUST fits and clears everything perfectly allowing me to have both.
I packaged up all the modified parts I used to install the duct and cable chain mount. Below is the link to Maker Forum post. Hopefully this helps someone.
https://www.makerforum.tech/d/52-ender-6-5015-petsfang-mount/46
Print Settings
Printer Brand:
Creality
Printer:
Ender 6
Rafts:
No
Supports:
Yes
Resolution:
.12
Infill:
60%
Category: 3D Printer Parts