Hand-Held Clothesline Spool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I just needed a small spool for my clothesline that I could wind by hand.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 438
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
This is actually a remix of some sample filament spool I found, but can't find the source anymore. (If you do know where it came from, PM me!)
One set includes a bearing hub where you can use any spool you want, it just needs adjusting in a slicer. The included hub is 42mm.
The other is a one-piece spool that only requires the bearing.
All that's required are two bearings and two screws.
In this particular case, I used an 8-32 2-inch screw and 2 bearings with a inner diameter close to the 4.1mm of the screw. I used heat shrink tubing to make up the difference in space.
The knob uses a 3mm screw, minimum 6mm, screwed from the inside.