4x 18650 multiple battery charger with space for 4056 circuit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Why charge one 18650 when you can charge up to 4 at a time! It just takes 4x as long of course. This also has a slight…
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 174
- Wydruki
- 0
- Wyświetlenia
- 1290
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Why charge one 18650 when you can charge up to 4 at a time!
It just takes 4x as long of course.
This also has a slight extension on the space available for the 4056 circuit, as the original design didn't fit the ones I have (which have a little extra plastic near the OUT- and OUT+ points)
The whole thing is quite chunky. If I had to do it again, I'd probably use a thinner design, but hey ho, this thing works fine for me!
Note: I've not made a cover for the circuits. Couldn't be bothered :).
Only use batteries which are of similar voltage at point of inserting. Preferably also from the same batch.
Finally, only use this design if you fully understand the risks associated! I bear no responsibility for any negative impacts you may experience from using this design!
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.28mm
Infill:
20%
Filament: Eryone PLA Silk Blue
Category: Electronics