1 / 9
spitvalve (waterkey) replacement for Allora Aere plastic trombone
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replace your broken spitvalve (waterkey) on the Allora Aere plastic trombone.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 42
- Wydruki
- 1
- Wyświetlenia
- 317
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution
Replace your broken spitvalve (waterkey) on the Allora Aere plastic trombone.
Print Settings
Printer:
Sovol SV01
Rafts:
No
Supports:
No
Resolution:
0.1 mm
Infill:
100%
Filament:
CC3D PETG
Red
Notes:
Installation instructions:
- Install the lever on the trombones slider by pressing it against the spring and lining up the axle hole.
- Slide in the axle.
- Lift the lever while holding the slider with the drainage hole pointing downwards.
- Put a small dollop of cyanoacrylate superglue on the corresponding surface on the lever.
- Turn the slider upside down while holding the lever lifted.
- Place the half sphere stopper on the seal of the drainage hole.
- Place a small dollop of polyurethane gorilla glue on the flat surface of the stopper.
- Release the lever allowing the spring to squeeze it against the stopper.
- Wait a couple of hours for the bond to form between the two parts.
Category: Music