1 / 9
spitvalve (waterkey) replacement for Allora Aere plastic trombone
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replace your broken spitvalve (waterkey) on the Allora Aere plastic trombone.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 42
- Makes
- 1
- Views
- 319
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution
Replace your broken spitvalve (waterkey) on the Allora Aere plastic trombone.
Print Settings
Printer:
Sovol SV01
Rafts:
No
Supports:
No
Resolution:
0.1 mm
Infill:
100%
Filament:
CC3D PETG
Red
Notes:
Installation instructions:
- Install the lever on the trombones slider by pressing it against the spring and lining up the axle hole.
- Slide in the axle.
- Lift the lever while holding the slider with the drainage hole pointing downwards.
- Put a small dollop of cyanoacrylate superglue on the corresponding surface on the lever.
- Turn the slider upside down while holding the lever lifted.
- Place the half sphere stopper on the seal of the drainage hole.
- Place a small dollop of polyurethane gorilla glue on the flat surface of the stopper.
- Release the lever allowing the spring to squeeze it against the stopper.
- Wait a couple of hours for the bond to form between the two parts.
Category: Music