Ridgid R4512 Table saw zero clearance throat plate (R4520?)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a zero clearance throat plate for Ridgid R4512 table saws. These may or may not work on R4520 saws? I believe…
- Ocena
- 0 / 5
- Polubienia
- 52
- Pobrania
- 360
- Wydruki
- 0
- Wyświetlenia
- 1904
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This is a zero clearance throat plate for Ridgid R4512 table saws.
These may or may not work on R4520 saws? I believe they are the same but I do not own one to verify.
Because the print is too large for most printers, it must be printed in 2 parts and glued together using the included dove tails. Print 2 of the smaller dove tails.
It's likely a good idea to print with supports for the part that overhangs.
At least 60% infill is recommended because you want this to have some weight to it.
See notes about what to do when done.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
Doesn't Matter
Supports:
Yes
Infill:
60
Post-Printing
Since this is too large for most printers, gluing the two pieces together has to be done.
The included dove tails should be a very exact fit and fixed in place with super glue. Be sure to keep the top as level as possible.
Glue a thin washer down to the front and enlarge the two screw holes to fit screws. Adjust those screws to get a snug fit.
Category: Parts