Fridge Ice Funnel Magnitized (Hydro Flask & Other) for Ice-Water Combo
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is to help dispense ice/water into containers that don't fit under your fridge slot, particularly Hydro Flask…
- Ocena
- 5 / 5
- Polubienia
- 30
- Pobrania
- 136
- Wydruki
- 1
- Wyświetlenia
- 1257
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
This is to help dispense ice/water into containers that don't fit under your fridge slot, particularly Hydro Flask insulated bottles with a 52mm inner diameter, although it's helpful for all sorts of containers. It's got two slots, where you can insert bar magnets (neodymium 60x10x3mm), although you'd only need to pick one of the slots if you only want to use one magnet.
This particular design is for a GE fridge where the ice and water dispenser are combined together, which differs from other designs I've found on Thingiverse. It's quite likely it'll work on many other brands of refrigerator dispensers that have the ice/water combo dispenser.
Print Settings
You'll need supports to accommodate the cut out on the top (print surface bottom) that helps it fit snug so no ice is lost when on "crushed mode".
A brim is highly recommended so the print attaches well to the surface. I suppose you could use a raft, but not necessary if you're comfortable with brim.
Ensure you change the wall count to 5 layers as that will actually reduce overall print time by about 2-3 hours vs using infill. [Ender 3V2 has a 9+38 print time for reference]
I'd like to give credit to GarageMonkeySan for the general idea from the link below, which I remixed prior to making this current design for a Water/Ice combo from scratch. https://www.thingiverse.com/thing:4614765
Print Settings
Rafts:
No
Supports:
Yes
Resolution:
0.2mm layers (0.4mm nozzle)
Infill:
Doesn't matter if you set 5 walls
Filament: Any PLA or PLA+ Any
Notes:
I can't stress enough that a brim is key to bed adhesion. I also want to stress that setting your wall count to 4 or 5 will save significantly on print time as well as increase durability.
Category: Kitchen & Dining