MK3s IR_Sensor LED Indicator (non-MMU)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Add LED and current limiting resistor to your IR Sensor. Two color print - MMU required.
- Ocena
- 5 / 5
- Polubienia
- 36
- Pobrania
- 200
- Wydruki
- 0
- Wyświetlenia
- 3483
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Need to give credit to ticktock for the original idea.
FYI: Two color print - MMU required. The indicator uses a green 1206 SMD LED and 22k-ohm SMD resistor. Wanted low current draw and low brightness from LED.
Obviously the tiny window should be printed with a clear or light colored filament.
Working with SMD components can be frustrating, and you could ruin your IR_Sensor board. I glue the SMD parts in place on the end of the IR board near +5V and Signal pin-outs, then carefully solder. Will add wiring diagram image as well. SMD Soldering at Home . . . Google for: wire wrapped around end of soldering-iron tip to reduce tip size.