Bumper extensions for iLife V5S Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was tired of my robot vacuum climbing on the footplate of my kitchen table, so I designed these bumper extensions…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 317
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I was tired of my robot vacuum climbing on the footplate of my kitchen table, so I designed these bumper extensions that will make it stop at any ~7 mm high obstruction. Obviously, it is not good for carpets ;)
Now with step file for remixing.
Print Settings
Printer:
Heavily modded Craftbot
Rafts:
No
Supports:
Yes
Resolution:
Anything up to about 0.25mm
Infill:
33%
Notes:
Use a tough material like ABS, PETG, tough PLA or even nylon, I suspect regular PLA will chip after a while. Print hot for good layer adhesion, the default model orientation should be best. Remove supports.
Mounting
Using a small Phillips screwdriver, unscrew the three little screws holding each of the two bottom parts of the bumper. Move the screws in the printed bumper extensions and screw them where the bottom parts were, taking care which part is on the left and which on the right.
I put one of the bottom parts of the bumper on my regular document scanner and made a .jpeg scan. I then took the scan and placed it into Fusion as a canvas and calibrated it using the distance between the furthest edges. After that it is just a matter of sketching on top of the canvas :)
Category: Parts