Ender 3 V2 Damper Feet (Soft Springs)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dampening feet for Ender 3v2 for reducing noise transfer from the printer to the table it is standing on.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 80
- Wydruki
- 0
- Wyświetlenia
- 1146
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
These dampening feet can be attached to the stock rubber feet. I designed them to be as springy as reasonably possible to reduce the noise emission from my printer to the table its standing on. Previously I made another version you can find here: I had to design another version as I added lots of additional weight to my printer. https://www.thingiverse.com/thing:4851034
Noise: With the printer standing at a IKEA Lack table these feet make a night and day difference in noise when printing at high speeds and accelerations.
Ringing: with these feet ringing seems to be a little better than without, but its marginal.
Notes:
- When used inside of an enclosure you should not use PLA as it will deform over timed. I used ASA for mine.
- The printer can shake quite a lot. This may look scary but is absolutely fine and wont affect print-quality
In order to install a new motherboard-cover I additionally used these riser feet (https://www.thingiverse.com/thing:4665097).
I added gcode with for a 0.6 mm nozzle for PLA.