1 / 1
Pellet ramp for traeger(tm) pro series smoker — zdjęcie 1

Pellet ramp for traeger(tm) pro series smoker

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

In order to make removal of pellets from a Traeger Pellet Smoker simpler, I have created this ramp.

Ocena
5 / 5
Polubienia
21
Pobrania
139
Wydruki
4
Wyświetlenia
906
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Instructions (please read!): 
Unfortunately, I did not create the STL model in proper orientation. Therefore you have to adjust orientation in your slicer before slicing it. The face with the 5 holes should be directly placed on the printbed.
When placed this way, you won't need to any supports to print the ramp.

Magnets:
After printing you can glue in up to 5 magnets in to the prepared holes (magnet diameter 12mm, height 2mm)

See picture how the ramp is attached to the smoker.

This was tested on a pro series 22 model, but might also fit on other Traeger smokers (e.g. D2 575 or 780 etc..), where the pellet outlet has a width of 110mm.

Tagi