Adjustable table cloth clamp supported
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This remix has an easily removable sacrificial support on the slide and spring so that slicer supports are not needed.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 37
- Wydruki
- 1
- Wyświetlenia
- 493
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
Love the original version of the adjustable table cloth clamp by @fl_mike. One outstanding issue is the “triangle” in the slide that needs supports. I added a sacrificial support, 0.2mm thick (one layer) as a bridge under the triangle that should be much easier to remove than slicer-generated supports.
All other print settings remain the same. If the clip is oriented lengthways in the Y-axis, I did not need any brim.
To remove the sacrificial support, I found that a narrow flat blade jewelers' screwdriver and a utility knife did a good job. In the picture, you can see a little bit of the support after cleanup on the right side, but it doesn't affect the sliding action at all.