Adjustable table cloth clamp supported
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This remix has an easily removable sacrificial support on the slide and spring so that slicer supports are not needed.
- Rating
- 5 / 5
- Likes
- 3
- Downloads
- 37
- Makes
- 1
- Views
- 493
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
Love the original version of the adjustable table cloth clamp by @fl_mike. One outstanding issue is the “triangle” in the slide that needs supports. I added a sacrificial support, 0.2mm thick (one layer) as a bridge under the triangle that should be much easier to remove than slicer-generated supports.
All other print settings remain the same. If the clip is oriented lengthways in the Y-axis, I did not need any brim.
To remove the sacrificial support, I found that a narrow flat blade jewelers' screwdriver and a utility knife did a good job. In the picture, you can see a little bit of the support after cleanup on the right side, but it doesn't affect the sliding action at all.