Raspberry Pi case for Lack enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An Octopi case that mounts to the Lack enclosure.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 60
- Wydruki
- 1
- Wyświetlenia
- 618
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This case for my Octopi mounts to the back of the Lack enclosure. It has openings for USB-C and one of the USB-A ports, the SD card, camera ribbon cable, and a cooling fan. I also printed a set of Lack enclosure parts for the right side leg so I could pass wires through that side as well.
Hardware needed:
(4) M3 x 8 screws to secure cover(or longer, up to 14mm)
(4) M2.5 x 6 screws to mount Raspberry Pi
(4) M2.5 screws to mount fan, length depends on your fan
(2) #10 wood screws, at least 1" long to mount case to Lack enclosure, or your own similar solution depending on your needs
* I like to tap holes rather than use nuts, so two metric taps will be needed (M3 and M2.5). I can remix this to use nuts if there's a need.
I printed this in PETG with supports under a few key areas, 0.2 mm quality, 50% infill