UPDATE! Fatshark Transformer - Side and Front Mount - DJI Analog V2 Adapter Case w\ RunCam DVR Case

UPDATE: I was not liking having the module on the side of the goggles, so I came up with an adapter that "hangs" on the 2 stock antenna mounts, I printed some antenna caps to hold it down, works very well, file ending in - Front Mount. It has 2 slots for holding the module box, but I have not printed that version of the box out yet and just using it on the existing one just fine, my resin printer is being a PITA right now..... But yea I stow my goggles in my bag with it on and have had no issues either. Hope you all find it useful :)

Like box goggles.... got yourself some FatShark Transformer goggles, wanna use a module, and get DVR. Here ya go! Works well. It is designed around the V2 DJI Analog adapter and Runcam DVR. just goes to AV in and run power through it and good to go, the V2 adapter has DVR pads on it. Im using it with a True D. It mounts on the right side.

I may try to add a small fan at some point, i live in Az so cooling matters....

I hope others can find this helpful :)

Adapter: https://www.amazon.com/Receiver-Adapter-Digital-Fatshark-RapidFire/dp/B08LMWTBJ9/ref=sr_1_1?dchild=1&keywords=DJI+adapter+v2+analog&qid=1629098896&sr=8-1

DVR: https://www.amazon.com/RunCam-AOKFLY-Recorder-Lossless-Quadcopter/dp/B07F2J4S23/ref=sr_1_2?dchild=1&keywords=runcam+DVR&qid=1629098867&sr=8-2

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

200

Infill:

Filament: eSun Resin Gray

Notes:

Category: Other