Raspberry Pi Official 7 Inch LCD 30° Mount/Bracket for 2020 Extrusions FLSUN SR
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix from the idea by jterranella (great idea by the way). I needed a bit of an angle (ca. 30°) to make the…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 1155
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is a remix from the idea by jterranella (great idea by the way). I needed a bit of an angle (ca. 30°) to make the Pi and monitore case nice and straight (and even!) on my FLSUN SR. I also added some chamfers and rounded corners just to please my OCD ;-) !
I mounted the bracket to the extrusion using M5x12mm screws and t-nuts. The LCD was mounted to the bracket using M3x12mm screws.
In the photos you can see the Pi/LCD mounted permanently ;-) to my FLSUN SR.
Remember to give my thing a"like", its very much appreciated :)
https://www.buymeacoffee.com/murdrrdbypirates
Thank you
Print Settings
Printer:
FLSUN Super Racer
Rafts:
No
Supports:
Yes
Resolution:
0.2 mm
Infill:
25%
Filament:
Polymaker PolyTerra PLA
Black
Notes:
Lay the bracket on its back and use supports to the buildplate on the shortest angled piece.
Category: 3D Printer Accessories