JGA5 Pi3 and 50x26mm relais mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount for a Raspberry Pi and a 26x50mm relais for a JGAurora A5 (but it's really generic, as it's a screw…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 159
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a mount for a Raspberry Pi and a 26x50mm relais for a JGAurora A5 (but it's really generic, as it's a screw based mount for a flat surface). The idea is that the Pi controls the controller board's power using the relais.
Warning: Since most relais are really only rated for up to 10A, it's really advisable to migrate at least the hotbed power onto a mosfet so that the board only delivers a control signal to the MOSFET. Otherwise you're likely to be above 10A.
Category: 3D Printer Parts