1 / 2
JGA5 Pi3 and 50x26mm relais mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a mount for a Raspberry Pi and a 26x50mm relais for a JGAurora A5 (but it's really generic, as it's a screw…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 9
- Makes
- 0
- Views
- 159
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
This is a mount for a Raspberry Pi and a 26x50mm relais for a JGAurora A5 (but it's really generic, as it's a screw based mount for a flat surface). The idea is that the Pi controls the controller board's power using the relais.
Warning: Since most relais are really only rated for up to 10A, it's really advisable to migrate at least the hotbed power onto a mosfet so that the board only delivers a control signal to the MOSFET. Otherwise you're likely to be above 10A.
Category: 3D Printer Parts