Pololu Gearmotor Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting bracket for Pololu gearmotors.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 160
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a mounting bracket for these Pololu gearmotors.
The motors press fit into the bracket, and then the bracket press fits into 1/8" laser cut plywood for your project. From there, a zip tie ensures it isn't going anywhere.
It is important that the legs are shorter than the thickness of your material, else the zip tie won't secure the bracket. There is a second model with half-length legs for thinner materials.
The mounting holes for the legs are 6.35mm square, and sit 25.4mm apart. They should sit 1.6mm from the edge of your material.
Note:
Print chamfered-face down with supports for the legs