Ultimaker 2 simple front panel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ultimaker 2 simple front panel and could be stored on the printer side Requirement: -Glue (I just used hot glue)…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 415
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Ultimaker 2 simple front panel and could be stored on the printer side
Requirement:
-Glue (I just used hot glue)
-1.8mm acrylic or plexiglass (325mm x 315mm)
Tip: Hold the acrylic panel in place with masking tape then apply glue to the brackets
This design is inspired by Ultiarjan Ultimaker2 minimalist front panel https://www.thingiverse.com/thing:581159
- 325mm is the distance between the printer virtual panels
- 315mm is the distance between the front panel screws to the top of the control rotation.
Print Settings
Printer Brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2
Infill:
20%
Filament: General ASA-ABS-PETG Any Color
Notes:
The side tabs might need some filing and cleaning as needed to hold the panel properly.
Category: 3D Printer Accessories