Divider for Sterilite 6qt bin
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fits in the bottom of a 6qt Sterilite container to divide the space in half
- Ocena
- 5 / 5
- Polubienia
- 43
- Pobrania
- 281
- Wydruki
- 0
- Wyświetlenia
- 1680
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Drops into a Sterilite 6qt bin to divide the bottom in half if you need more granular storage.
I printed with no top or bottom layers to get only infill which dramatically reduced the print time.
Three versions available:
- sized to slice on PrusaSlicer for the MK3* at 0.3mm layer height, the wall thickness of 1.1mm results in two shells for quick printing.
- sized to slice on PrusaSlicer for the MK3* at 0.2mm layer height with a thinner wall of 0.86mm. Would be lighter but slower to print due to the smaller layer height, don't know why you'd want this choice.
- sized to slice on Cura or similar that sets extrusion thickness to 0.4mm
Another option if you don't need it strong, or have a larger diameter nozzle - you can print any one of the three in vase mode. (PrusaSlicer: Print Settings tab, Spiral Vase under “Vertical Shells”, Bambu Studio or OrcaSlicer: “Spiral vase” under Others, Special Mode. Been a long time since I've used Cura so don't remember where that's set) One issue I've had with this approach is I haven't been able to figure out how to do only infill (not solid layers) on the bottom to save time.
I only use the first model but provided the other two if it might be useful to someone.