1 / 1
Drybox for 2kg filament and Prusa MK3S+ Topmount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Drybox can handle the Prusament Recycled Filament with a 2 kg spool and (optionally) put it on top of the printer.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 1410
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (16)Wydruki i komentarze (Wydruki: 0) (Komentarze: 2)Remiksy (0)Kolekcje (42)Powiązane
The Drybox is a remix and recreation of above models. It is build to fit directly on top of the Prusa MK3S+ Printer and has a shaft to hold the spool, so no need for any bearings and other tubes.
To attach everything you will need this:
- 2x M3x30 screws to put top and bottom case together
- 1x M3x10 screw for mounting the closing knob
- 1x M3x5 screw for the closing knob in the upper lid
- 8x M4x12 screws to attach the holders with nuts and washers below
- 8x M4 nuts
- printing this is optional, but I recommend it
- 2x PC4-M10 Holder
- 1x M10 nut with washer
- 1m Teflon/PTFE Tube with 2mm inner and 4mm outer diameter
- silica gel
My gcode is for PETG but with only 205/80°C, because PETG works best without stringing at this Temperature for me. Please change this to your best printing Temperature!