Covers for MP Select Mini 4DM Enhanced Side Panel Unused Switch Holes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have the 4DM enhanced side panels on my MP Select mini and don't use the holes for the switches so I wanted them…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 129
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I have the 4DM enhanced side panels on my MP Select mini and don't use the holes for the switches so I wanted them covered, these just simple covers that fit in tightly. Just push them in and that's it.
Print Settings
Printer:
mp select mini
Rafts:
Yes
Supports:
Doesn't Matter
Resolution:
your choice
Infill:
0%
Notes:
I used 0% infill and it works fine
yes I used a brim as it's small to make sure it stays down
resolution doesn't matter, your choice
doesn't need supports
Post-Printing
trimming
I made these to be a very tight fit, you may have to trim just slightly to get them in and make sure brim is cleaned off. Just use hobby knife or similar.
Category: 3D Printer Parts