Esk8 Boardstand V2

This is a heavy remix of the E-TOXX Foldable Boardstand (https://www.thingiverse.com/thing:3339894).

I ran with the general profile and made some major modifications to create a strong & stable board stand.

• Designed to allow for very tight motor-truck spacing (aka gear drives) - fits either truck
• Designed to assemble with no fasteners required (snug fit and 3D printed pins)
• Shorter overall height (Now fits 9" dia tires)
• No moving parts
• Smaller parts = shorter print time
• No support required during printing
• Entire stand prints at once on a 225x225 / 250x210 or larger bed (~18 hours)
• Very strong and stable
• Fits any truck size/profile

Print Settings:

• 0.2mm layers
• 20% infill (I prefer gyroid)
• At least 6 solid perimeters and top/bottom layers (key to strength)
• No support
• PLA or better

Notes:

• You need QTY 2 CROSSBARS
• You need QTY 2 UPRIGHTS
• You need QTY 4 PINS
• Print pins laying horizontal on the bed.
• Print one of each size pin (small, medium, large) and test fit. Pins should be snug but not impossible to assemble. Once you've found the correct gap/tolerance for your printer, print the full set of 4
• Alternatively, plastic pins can be replaced y M4x25mm (or 8-32 x 1") bolts & nuts
• All parts are symmetric - assemble parts in any direction