Vive Controller IKEA Skadis (SKÅDIS) Hook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Super simple modification to 2 designs already made. I reduced the height of the top of the clip, so the hook won't…
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 129
- Wydruki
- 2
- Wyświetlenia
- 632
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Super simple modification to 2 designs already made.
I reduced the height of the top of the clip, so the hook won't block the holes above. Also to make it easier to slot in.
I did keep a little bit of the hook's length running along the middle, since if I had brought it closer to make it flush, it was hard to remove.
Also the distance between two controllers is absolutely perfect, it's like it was made for it :)
Printed in PLA. The filament I used was "PrimaValue PLA White" (Amazon affiliate link): https://amzn.to/2Ich0Ri
Print Settings
Printer:
JGAURORA A5
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
25-40%
Notes:
Make sure to print it on its side as shown. You WILL need supports set to "Everywhere", mostly for the cable holder in the middle, but also if the angle is too harsh for your printer. White looks best in my opinion, but feel free to change it up :)
Category: Video Games